Point d'accès Aruba (HPE) JW326A

AP-320 SERIES SPECIFICATIONS

·         AP-325 and IAP-325

·         5 GHz (1,733 Mbps max rate) and 2.4 GHz (600 Mbps max rate) radios, each with 4x4 MIMO support and a total of eight integrated omni-directional downtilt antennas.

·         AP-324 and IAP-324

·         5 GHz (1,733 Mbps max rate) and 2.4 GHz (600 Mbps max rate) radios, each with 4x4 MIMO support and a total of four combined, diplexed (dual-band) external RP-SMA antenna connectors.

WIRELESS RADIO SPECIFICATIONS

·         AP type: Indoor, dual radio, 5 GHz 802.11ac and 2.4 GHz 802.11n 4x4 MIMO.

·         Software-configurable dual radio supports 5 GHz (Radio 0) and 2.4 GHz (Radio 1).

·         Four spatial stream SU-MIMO for up to 1,733 Mbps wireless data rate to a single client device.

·         Three spatial stream MU-MIMO for up to 1,300 Mbps wireless data rate to up to three MU-MIMO capable client devices simultaneously.

·         Support for up to 256 associated client devices per radio, and up to 16 BSSIDs per radio.

·         Supported frequency bands (country-specific restrictions apply):

·         2.400 to 2.4835 GHz

·         5.150 to 5.250 GHz

·         5.250 to 5.350 GHz

·         5.470 to 5.725 GHz

·         5.725 to 5.850 GHz

·         Available channels: Dependent on configured regulatory domain.

·         Dynamic frequency selection (DFS) optimizes the use of available RF spectrum.

·         Supported radio technologies:

·         802.11b: Direct-sequence spread-spectrum (DSSS)

·         802.11a/g/n/ac: Orthogonal frequency-division multiplexing (OFDM)

·         Supported modulation types:

·         802.11b: BPSK, QPSK, CCK

·         802.11a/g/n/ac: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM

·         Transmit power: Configurable in increments of 0.5 dBm

·         Maximum (aggregate, conducted total) transmit power (limited by local regulatory requirements):

·         2.4 GHz band: +24 dBm (18 dBm per chain)

·         5 GHz band: +24 dBm (18 dBm per chain)

·         Note: conducted transmit power levels exclude antenna gain. For total (EIRP) transmit power, add antenna gain

·         Advanced Cellular Coexistence (ACC) minimizes interference from cellular networks.

·         Maximum ratio combining (MRC) for improved receiver performance.

·         Cyclic delay/shift diversity (CDD/CSD) for improved downlink RF performance.

·         Short guard interval for 20-MHz, 40-MHz and 80-MHz channels.

·         Space-time block coding (STBC) for increased range and improved reception.

·         Low-density parity check (LDPC) for high-efficiency error correction and increased throughput.

·         Transmit beamforming (TxBF) for increased signal reliability and range.

·         Supported data rates (Mbps):

·         802.11b: 1, 2, 5.5, 11

·         802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54

·         802.11n: 6.5 to 450 (MCS0 to MCS23)

·         802.11ac: 6.5 to 1,733 (MCS0 to MCS9, NSS = 1 to 4)

·         802.11n high-throughput (HT) support: HT 20/40

·         802.11ac very high throughput (VHT) support: VHT 20/40/80

·         802.11n/ac packet aggregation: A-MPDU, A-MSDU

POWER

·         Maximum (worst-case) power consumption: 20W (802.3at PoE), 13.5W (802.3af PoE) or 18.5W (DC)

·         Excludes power consumed by external USB device (and internal overhead); this could add up to 6W (POE) or 5.5W (DC) for 5W/1A USB device

·         Maximum (worst-case) power consumption in idle mode: 8W (PoE) or 7W (DC).

·         Direct DC source: 48Vdc nominal, +/- 5%.

·         Power over Ethernet (PoE): 12 Vdc (nominal) 802.3af/802.3at compliant source

·         Unrestricted functionality with 802.3at PoE

·         Power-save mode with reduced functionality from 802.3af PoE

·         USB port disabled

·         Second Ethernet port disabled

·         2.4 GHz radio in 1x1:1 mode

·         Power sources sold separately

·         When both power sources are available, DC power takes priority

WI-FI ANTENNAS

·         AP-324/IAP-324:

·         Four RP-SMA connectors for external dual band antennas. Internal loss between radio interface and external antenna connectors (due to diplexing circuitry): 2.5 dB in 2.4 GHz and 1.5 dB in 5 GHz.

·         AP-325/IAP-325:

·         Eight integrated downtilt omni-directional antennas for 4x4 MIMO with maximum antenna gain of 4.0 dBi in 2.4 GHz and 4.7 dBi in 5 GHz. Built-in antennas are optimized for horizontal ceiling-mounted orientation of the AP. The downtilt angle for maximum gain is ~ 30 degrees. Combining the patterns of each of the antennas of the MIMO radios, the peak gain of the effective per-antenna pattern is 2.7dBi in 2.4GHz and 2.9dBi in 5GHz.

OTHER INTERFACES

·         Two 10/100/1000BASE-T Ethernet network interfaces (RJ-45)

·         Auto-sensing link speed and MDI/MDX

·         Load balancing support to achieve platform throughput greater than 1 Gbps

·         802.3az Energy Efficient Ethernet (EEE)

·         PoE-PD: 48 Vdc (nominal) 802.3af or 802.3at PoE

·         DC power interface, accepts 2.1/5.5-mm center-positive circular plug with 9.5-mm length

·         USB 2.0 host interface (Type A connector)

·         Bluetooth Low Energy (BLE) radio

·         Up to 4dBm transmit power (class 2) and -94dBm receive sensitivity

·         Integrated antenna, -5dBi gain (30 degree downtilt)

·         Can be disabled with configuration

·         Visual indicators (tri-color LEDs): For system and radio status

·         Reset button: Factory reset (during device power up)

·         Serial console interface (RJ-45)

·         Kensington security slot

MOUNTING

·         The AP ships with two (white) mounting clips to attach to a 9/16-inch or 15/16-inch flat T-bar drop-tile ceiling.

·         Several optional mount kits are available to attach the AP to a variety of surfaces; see the Ordering Information section below for details

MECHANICAL

·         Dimensions/weight (unit, excluding mount accessories):

·         203 mm (W) x 203 mm (D) x 57 mm (H), 8.0” (W) x 8.0” (D) x 2.2” (H)

·         950 g/34 oz

·         Dimensions/weight (shipping):

·         315 mm (W) x 265 mm (D) x 100 mm (H), 12.4” (W) x 10.4” (D) x 3.9” (H)

·         1,350 g/48 oz

ENVIRONMENTAL

·         Operating:

·         Temperature: 0° C to +50° C (+32° F to +122° F)

·         Humidity: 5% to 93% non-condensing

·         Storage and transportation:

·         Temperature: -40° C to +70° C (-40° F to +158° F)

REGULATORY

·         FCC/Industry of Canada

·         CE Marked

·         R&TTE Directive 1995/5/EC

·         Low Voltage Directive 72/23/EEC

·         EN 300 328

·         EN 301 489

·         EN 301 893

·         UL/IEC/EN 60950

·         EN 60601-1-1 and EN 60601-1-2

For more country-specific regulatory information and approvals, please see your Aruba representative.

RELIABILITY

MTBF: 739,935 hrs (84.5yrs) at +25C operating temperature (AP-325)

REGULATORY MODEL NUMBERS

·         AP-324 and IAP-324: APIN0324

·         AP-325 and IAP-325: APIN0325

CERTIFICATIONS

·         CB Scheme Safety, cTUVus

·         UL2043 plenum rating

·         Wi-Fi Alliance (WFA) certified 802.11a/b/g/n/ac

·         Bluetooth SIG interoperability certification

·         Passpoint® (Release 2) with ArubaOS and Instant 8.3+

WARRANTY

Aruba limited lifetime warranty